Keysight N432A Programming Manual page 323

MEMory[:METer][1]:TABLe:MOVE
<character_data>,<character_data>
This command is used to rename a sensor calibration table or a
frequency-dependent offset table.
Syntax
MEM :MET
Parameters
Item
character_data
(1st parameter)
character_data
(2nd parameter)
Example
MEM:TABL:MOVE "tab1","tab1a"
Keysight N432A Programming Guide
:TABL
1 :MOVE
Description/Defaul t
Contains the existing table name
Specifies the new table name. A maximum of
12 characters can be used.
Space character_data
This command renames a table
named tab1 to tab1a.
MEMory Subsystem
,
,
character_data
Range of values
Existing table name
A to Z (uppercase)
a to z (lowercase)
0 to 9
_ (underscore)
10
323