Keysight N432A Programming Manual page 185

READ[1]|2|3|4 Queries
The READ? query is most commonly used with the CONFigure command to cause
a new power measurement to be taken and the result returned to the output
buffer. The format of the result is set by FORMat[:READing][:DATA]. Refer to
Chapter
For the N432A carrying out a single measurement, the READ? query is equivalent
to:
INITiate
FETCh?
For the N432A carrying out a difference measurement, the READ:DIFFerence?
query is equivalent to:
INITiate
FETCh:DIFFerence?
For the N432A carrying out a ratio measurement, the READ:RATio? query is
equivalent to:
INITiate
FETCh:RATio?
Keysight N432A Programming Guide
7, "FORMat Subsystem"
MEASurement Commands
on page 277 for further information.
3
185