Keysight N432A Programming Manual page 461

SYSTem:PRESet
This command is used to preset the N432A to its default settings. The result from
this command execution is similar to the *RST command. Refer to
more information on the preset settings.
All settings apply to both *RST and SYSTem:PRESet unless stated otherwise.
NOTE
Syntax
SYST
Example
SYST:PRES
Table 15-1 Preset settings
Command
CONF[1] |2|3|4?
CALC[1]|2|3|4:HOLD:STAT
CALC[1]|2|3|4:FEED[1]|2
CALC[1]|2|3|4:GAIN[:MAGN]
CALC[1]|2|3|4:GAIN:STAT
CALC[1]|2|3|4:LIM:CLE:AUTO
CALC[1]|2|3|4:LIM:LOW[:DATA]
Keysight N432A Programming Guide
:PRES
This command presets the N432A.
Preset setting
Command function: POW:AC
Expected power level: +20 dBm
Resolution: 3
OFF
POW:AVER
0.000 dB
OFF
ON
–90 dBm
SYSTem Subsystem
Table 15-1
Remark
Returns the current
configuration
Hold disabled
Select the average
measurement mode
Display offset value
Display offset disabled
Clear limit data at INIT
Lower limit
15
for
461