Keysight N432A Programming Manual page 225

CALCulate[1]|2|3|4:LIMit:CLEar:AUTO <boolean>|ONCE
This command controls when the fail counter (FCO) is cleared of any limit failures
for the specified window/measurement. The FCO is used to determine the results
returned by the CALCulate[1]|2|3|4:LIMit:FAIL? query.
– If ON is specified, the FCO is set to 0 each time a measurement is:
– If OFF is specified, the FCO is not cleared by the above commands.
– If ONCE is specified, the FCO is cleared only after the first initialization then
Syntax
Example
CALC:LIM:CLE:AUTO 1
Keysight N432A Programming Guide
– Initiated using INITiate[:IMMediate]
– Initiated using INITiate:CONTinuous ON
– Measured using MEASure?
– Read using READ?
starts accumulating any limit failures.
CALC 1
2
3
4
:LIM :CLE
This command switches on automatic clearing of
the FCO for the upper window/upper
measurement.
CALCulate Subsystem
Space
:AUTO
?
4
0|OFF
1|ON
ONCE
225