Keysight N432A Programming Manual page 473

INITiate[1]:CONTinuous <boolean>
This command sets the N432A for either a single trigger cycle or continuous
trigger cycles. A trigger cycle means that the N432A exits the wait-for-trigger
state and starts a measurement.
If INITiate:CONTinuous is set to:
– OFF, the trigger system remains in the idle state until it is set to ON, or
– ON, the trigger system is initiated and exits the idle state. On completion of
– This command performs the same function as
NOTE
– When entering local mode, INITiate:CONTinuous is set to ON.
Syntax
Example
INIT:CONT ON
Keysight N432A Programming Guide
INITiate:IMMediate is received. Once this trigger cycle has completed, the
trigger system returns to the idle state.
each trigger cycle, the trigger system immediately commences another trigger
cycle without entering the idle state.
INITiate:CONTinuous:SEQuence[1] <boolean>.
INIT :CONT
1
This command places the N432A in the wait-for-trigger
state.
Space
0|OFF
1|ON
?
TRIGger Subsystem 16
473