Keysight N432A Programming Manual page 427

STATus Subsystem 14
Bit 1 is set when any of the following errors occur:
– Error –231,"Data questionable; Input Overload"
– Error –231,"Data questionable; Input Overload ChA"
Bits 3 is set when the following errors occur:
– Error –230,"Data corrupt or stale"
– Error –231,"Data questionable; Upper window log error"
Bit 4 is set when the following errors occur:
– Error –230,"Data corrupt or stale"
– Error –231,"Data questionable; Lower window log error"
Bit 5 is set when channel A requires zeroing.
These bits are cleared when no errors or events are detected by the N432A during
a measurement covering the causes given for it to set.
Syntax
:POW :SUMM
STAT :QUES
Keysight N432A Programming Guide 427