Table of Contents
Advertisement
DISPlay[:WINDow[1]|2][:STATe] <boolean>
This command enables or disables the upper or lower window (WINDow1 and
WINDow2 respectively) so that the display shows a single window only. The
displayed window is presented in the expanded format, showing only a single
measurement; either the single measurement that was shown on the window or
the currently selected measurement, if two measurements had been shown.
Syntax
Examples
DISP:WIND2:STAT OFF
DISP:WIND2:STAT ON
Reset condition
On reset, both the upper and lower windows are enabled.
Keysight N432A Programming Guide
DISP
:WIND
1
:STAT
2
This command disables the lower window. The
upper window is shown in the expanded format,
displaying its currently selected measurement.
This command enables the lower window so
that a dual window display is once more
provided.
DISPlay Subsystem
Space
0|OFF
1|ON
?
6
275
Advertisement
Table of Contents
