Keysight N432A Programming Manual page 273

DISPlay[:WINDow[1]|2]:SELect[1]|2
This command is used to select a specific measurement within a specific window.
If the second numeric value is not specified, the upper measurement of the
relevant window is selected. This command specifies which measurement is to be
used for the analog or single numeric display.
Syntax
Example
DISP:WIND2:SEL1
Reset condition
On reset, the upper measurement of the upper window is selected.
Query
DISPlay[:WINDow[1]|2]:SELect[1]|2?
This query enters a 1 or 0 into the output buffer indicating whether the specified
measurement of the specified window is currently selected.
– 1 is returned if the specified measurement of the specified window is selected
– 0 is returned if the specified measurement of the specified window is not
Keysight N432A Programming Guide
DISP :WIND
selected
1 :SEL
2
This command selects the upper measurement of the
lower window.
DISPlay Subsystem
1
2
?
6
273