Keysight N432A Programming Manual page 485

TRIGger[1][:IMMediate]
This command causes a trigger to occur immediately, provided the N432A is in
the wait-for-trigger state. When this command is executed, the measurement
result is stored in the N432A memory. Use FETCh? to place the result in the output
buffer.
TRIGger[1]:DELay:AUTO is ignored if TRIGger[1][:IMMediate] is set to ON.
This command performs the same function as INITiate[1][:IMMediate].
NOTE
Syntax
Example
TRIG
Error message
If the N432A is not in the wait-for-trigger state, then TRIGger[1][:IMMediate]
causes error –211,"Trigger ignored".
Keysight N432A Programming Guide
TRIG 1
This command causes a N432A trigger to occur immediately.
:IMM
TRIGger Subsystem 16
485