Keysight N432A Programming Manual page 208

3 MEASurement Commands
Parameters
Refer to
parameters in this command.
Item
expected_value
(for the expected
power level)
resolution
source list
[a] The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the command
[b] When the measurement result is linear, this parameter represents the number of significant digits. When the
Example
MEAS2:RAT? DEF,1,(@1),(@1) Queries the ratio measurement of
208
"Optional parameters"
Description/Defaul t
The N432A ignores the numeric value entered for this
parameter. Any value entered is treated like DEF.
A numeric value for the resolution. If unspecified, the
current resolution setting is used.
Specifies the channels for calculating the ratio value. If
unspecified and the current window setup is a ratio
measurement, then this setup is used, otherwise it
defaults to A/A.
subsystems. The parameters must be entered in the specified order. If parameters are omitted, they default from
the right. The parameter DEFault is used as a placeholder. Specifying DEF leaves the parameter value unchanged.
measurement result is logarithmic, 1 to 4 represent 1, 0.1, 0.01, and 0.001 respectively.
on page 146 for additional details on the
Channel A/Channel A with relative mode off
for the lower window/upper measurement,
using the current expected power level and
a resolution setting of 1.
Keysight N432A Programming Guide
Range of values
Sensor dependent
[a]
DEF
[b]
1 to 4
1.0, 0.1, 0.01, 0.001
[a]
DEF
(@1),(@1)