Table of Contents
Advertisement
3
MEASurement Commands
Parameters
Refer to
parameters in this command.
Item
expected_value
(for the expected
power level)
resolution
source list
[a] The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the command
[b] When the measurement result is linear, this parameter represents the number of significant digits. When the
Example
MEAS2? -70DBM,1,(@1)
200
"Optional parameters"
Description/Defaul t
This parameter can be set to DEF or a numeric value.
The units of measurement are dBm and W. The default
unit is defined by UNIT:POWer.
A numeric value for the resolution. If unspecified, the
current resolution setting is used.
The channel which the command is implemented on. If
unspecified, the current window setup is used.
subsystems. The parameters must be entered in the specified order. If parameters are omitted, they default from
the right. The parameter DEFault is used as a placeholder. Specifying DEF leaves the parameter value unchanged.
measurement result is logarithmic, 1 to 4 represent 1, 0.1, 0.01, and 0.001 respectively.
on page 146 for additional details on the
Queries the lower window/upper measurement,
using an expected power level of –70 dBm and a
resolution setting of 1.
Keysight N432A Programming Guide
Range of values
Sensor dependent
[a]
DEF
[b]
1 to 4
1.0, 0.1, 0.01, 0.001
[a]
DEF
(@1)
Advertisement
Table of Contents
