Keysight N432A Programming Manual page 228

4 CALCulate Subsystem
CALCulate[1]|2|3|4:LIMit:FAIL?
This query enters a 1 or 0 into the output buffer indicating whether there have
been any limit failures for the specified window/measurement. A limit failure is
defined as CALC[1]|2|3|4:LIMit:FCO? being non-zero. The fail counter (FCO)
can be zeroed using the CALC[1]|2|3|4:LIMit:CLEar command.
– 1 is returned if one or more limit failures have occurred
– 0 is returned if no limit failures have occurred
Syntax
Example
CALC1:LIM:FAIL?
Reset condition
On reset, the buffer is set to zero for both the upper and lower windows/
measurements.
228
CALC 1
2
3
4
:FAIL
:LIM
Queries if there have been any limit failures for the
upper window/upper measurement.
?
Keysight N432A Programming Guide