Keysight N432A Programming Manual page 255

DISPlay:ENABle <boolean>
This command is used to enable and disable the display. At power up, the display
is always enabled.
Syntax
Example
DISP:ENAB 0
Reset condition
On reset, the display is enabled.
Query
DISPlay:ENABle?
This query enters a 1 or 0 into the output buffer indicating whether the display is
enabled or disabled.
– 1 is returned if the display is enabled
– 0 is returned if the display is disabled
Query example
DISP:ENAB?
Keysight N432A Programming Guide
DISP
:ENAB
Queries whether the display is turned on or off.
Space
0|OFF
1|ON
?
This command disables the display.
DISPlay Subsystem 6
255