Keysight N432A Programming Manual page 452

15 SYSTem Subsystem
–
Exponent too large
123
A numeric parameter was found whose exponent was larger than 32000
Example: CAL:RCF 1E34000
–
Too many digits
124
A numeric parameter was found whose mantissa contained more than 255 digits, excluding leading zeros
–
Numeric data not allowed
128
A numeric value was received within a command which does not accept a numeric value
Example: MEM:CLE 24
–
Invalid suffix
131
A suffix was incorrectly specified for a numeric parameter. You may have misspelled the suffix.
Example: SENS:FREQ 200KZ
– Suffix too long
134
A suffix used contained more than 12 characters
Example: SENS:FREQ 2MHZZZZZZZZZZZ
– Suffix not allowed
138
A suffix was received following a numeric parameter which does not accept a suffix
Example: INIT:CONT 0Hz
– Character data not allowed
148
A discrete parameter was received but a character string or a numeric parameter was expected. Check the
list of parameters to verify that you have used a valid parameter type.
Example: MEM:CLE CUSTOM_1
–
Invalid string data
151
An invalid string was received. Check to see if you have enclosed the character string in single or double
quotes.
Example; MEM:CLE "CUSTOM_1
–
String data not allowed
158
A character string was received but is not allowed for the command. Check the list of parameters to verify that
you have used a valid parameter type.
Example: LIM:STAT 'ON'
–
Invalid block data
161
A block data element was expected but was invalid for some reason, for example, *DDT #15FET. The 5 in
the string indicates that five characters should follow, whereas in this example there are only three.
–
Block data not allowed
168
A legal block data element was encountered but not allowed by the N432A at this point
Example: SYST:COMM:GPIB:ADDR #15FETC?
452 Keysight N432A Programming Guide