Upstream-Sla; Upstream-Sla Service-Mode Enable - H3C S7500E Series Command Reference Manual

upstream-sla

Syntax
upstream-sla { minimum-bandwidth value1 | maximum-bandwidth value2 | delay { low | high } } *
undo upstream-sla
View
ONU port view
Default Level
2: System level
Parameters
minimum-bandwidth value1: Specifies the minimum uplink bandwidth, in the unit of 64 kbps. value1
is in the range 8 to 15200 and defaults to 32.
maximum-bandwidth value2: Specifies the maximum uplink bandwidth, in the unit of 64 kbps. value2
is in the range 8 to 16000 and defaults to 368.
delay: Specifies the delay mode. The low keyword means that low delay is adopted and the high
keyword is high delay. Low delay is adopted by default.
Description
Use the upstream-sla command to set the ONU's minimum uplink bandwidth, maximum uplink
bandwidth, and delay mode of packet forwarding through the EPON system.
Use the undo upstream-sla command to restore the default values.
The sum of the minimum uplink bandwidths configured for all the created ONU ports under an OLT
port cannot exceed 972800 kbps, that is, 950 Mbps.
Examples
# Set the ONU port's minimum uplink bandwidth to 9600 kbps and maximum uplink bandwidth to
12800 kbps.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] upstream-sla minimum-bandwidth 150 maximum-bandwidth 200
Info: The minimum-bandwidth of upstream is 9600 Kbps
Info: The maximum-bandwidth of upstream is 12800 Kbps

upstream-sla service-mode enable

Syntax
upstream-sla service-mode enable
undo upstream-sla service-mode enable
View
ONU port view
3-44