Lldp Compliance Admin-Status Cdp - H3C S3100 Series Command Manual

Parameters
interval: LLDP polling interval to be set, in the range 1 to 30 (in seconds).
Description
Use the lldp check-change-interval command to enable LLDP polling and set the polling interval.
Use the undo lldp check-change-interval command to restore the default.
By default, LLDP polling is disabled.
Examples
# Enable LLDP polling on Ethernet1/0/1, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lldp check-change-interval 30

lldp compliance admin-status cdp

Syntax
lldp compliance admin-status cdp { disable | txrx }
View
Ethernet interface view
Parameters
disable: Specifies the disable mode, where CDP-compatible LLDP neither receives nor transmits CDP
packets.
txrx: Specifies the TxRx mode, where CDP-compatible LLDP can send and receive CDP packets.
Description
Use the lldp compliance admin-status cdp command to configure the operation mode of
CDP-compatible LLDP on a port or port group.
By default, CDP-compatible LLDP operates in disable mode.
Notes that:
Of the S3100 series, only the S3100-EI series switches support the CDP compatibility function.
To have your device work with Cisco IP phones, you must enable CDP-compatible LLDP globally
and then configure CDP-compatible LLDP to work in TxRx mode on the specified port(s).
Related commands: lldp compliance cdp.
Examples
# Configure CDP-compatible LLDP to operate in TxRx mode on Ethernet1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lldp compliance admin-status cdp txrx
1-15