Cdp-Compatible Lldp Configuration Example - H3C SR8800 Configuration Manual

Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1 [GigabitEthernet4/1/1]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV
Port 2 [GigabitEthernet4/1/2]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV
The output shows that GigabitEthernet 4/1/2 of Router A does not connect any neighboring
router.

CDP-compatible LLDP configuration example

Network requirements
As shown in
Figure 56 Network diagram
Configuration procedure
Configure CDP-compatible LLDP on Router A:
1.
# Enable LLDP globally and enable LLDP to be compatible with CDP globally.
[RouterA] lldp enable
[RouterA] lldp compliance cdp
Figure 56, enable CDP compatibility of LLDP on Router A.
: 4
: 2s
: 2s
: 5s
: 3
: Enable
: Rx_Only
: No
: 0s
: 1
: 1
: 0
: 0
: 5
: Enable
: Rx_Only
: No
: 0s
: 0
: 0
: 0
: 0
: 0
147