Ip Igmp Startup-Query-Interval - Allied Telesis x510-28GTX Command Reference Manual

IGMP IGMP S C
AND NOOPING OMMANDS
- -
IP IGMP STARTUP QUERY INTERVAL

ip igmp startup-query-interval

Overview Use this command to configure the IGMP startup query interval for an interface.
The IGMP startup query interval is the amount of time in seconds between
successive IGMP General Query messages sent by a querier during startup. The
default IGMP startup query interval is one quarter of the IGMP query interval value.
Use the no variant of this command to return an interface's configured IGMP
startup query interval to the default.
ip igmp startup-query-interval <startup-query-interval>
Syntax
no ip igmp startup-query-interval
Default The default IGMP startup query interval is one quarter of the IGMP query interval
value.
NOTE
Mode Interface Configuration for a VLAN interface.
Example To set the IGMP startup query interval to 15 seconds for vlan2, which is one quarter
of the IGMP query interval of 60 seconds, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ip igmp last-member-query-interval
Commands
ip igmp query-interval
ip igmp startup-query-count
C613-50170-01 Rev B
Parameter
<startup-query-interval>
: The IGMP startup query interval must be one quarter of the IGMP query interval.
configure terminal
interface vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specify the IGMP startup query interval, in the
range of 2-1800 seconds. The value must be one
quarter of the IGMP query interval value.
ip igmp query-interval 60
ip igmp startup-query-interval 15
1234