Subaru XT 1988 Service Manual page 149

ON-CAR SERVICES
2-2
(1800 cc model)
FULL
LOW
(2700 cc model)
Fig. 10
~When
reserve tank is empty,
Q check radiator
When reserve tank is empty,
~
check radiator.
,
~Reserve
tank
~,
To engine
FULL (
ali
LOW~
~~
L1-155
L2-1405
2) Replacement work.
Refer to 1-5 "Periodic Maintenance Services".
High Tension Cords
INSPECTION
Check for:
1) Damage to cords, deformation, burning or rust formation
of terminals.
2) Resistance values of cords.
Unit: [kn]
~
1800 cc model
2700 cc model
Distributor cord 2.43 - 5.67 2.43 - 5.67
#1 cord 9.87 - 23.03 10.86 - 25.33
#2
cord
2.83 - 6.61 5.67 - 13.24
#3
cord
11.21 - 26.16 11.24 - 26.23
#4
cord 2.27 - 5.29
4.52 - 10.55
#5
cord
-
11.43 - 26.68
#6
cord
-
2.60 - 6.07
9
Cylinder Head Bolts
(1800 cc engine only)
RETORQUING
After completing engine ASSY and mounting engine on car, be
sure to retighten cylinder head bolts.
1) Warm up engine.
2} After engine has cooled down, remove right and left
valve rocker covers.
3) Loosen intake manifold mounting bolts next to cylinders
No.1 and No.3 by 60°. Do not loosen the manifold mounting
bolts next to cylinders No.2 and No.4.
Do not loosen the mounting bolts more than 90°, or water
may leak.
4} Loosen bolt at position
CD
in Figure, and apply oil to
the thread. Repeat "loosen and tighten" operation four to
five times within the 60° range for a better fit, then tighten
bolt to the specified torque.
®
®
®
®
®
-;/®'----CD \
Retightening cylinder head bolts
L2·583
Fig. 11
Apply oil here.
Bolt loosening engle and oiling position.
L2·584
Fig. 12