Subaru XT 1988 Service Manual page 153

ON-CAR SERVICES 2-2
8) Remove the radiator fan shroud ASSY. While moving
condenser fan shroud ASSY in the direction in which radiator
fan shroud ASSY was installed, lift it out.
9) Remove the pulser ASSY (A/C).
10} Loosen the tension pulley lock nut to release V-belt ten-
sion. When removing V-belt, check that adjuster bolt is turned
counterclockwise fully in the direction which loosens the belt.
Fig. 23
11) Remove the alternator, alternator bracket and tension
pulley (RH).
12) Remove the water pump pulley.
13) Attach the STOPPER [49827700 (MT)/498497000
(AT)] to flywheel or torque converter to prevent it from
turning. Remove the crank pulley.
14) Remove the LH, RH and CTR belt covers in that order.
15) Remove the right timing belt.
Draw an arrow on the left and right belts with a piece of chalk
to indicate the direction of advance.
Fig.
24
(1) Loosen the two bolts wh ich secu re the tensioner.
Move the tensioner in the direction which loosen it and
temporarily tighten the bolts.
Fig.
25
(2)
Remove the right timing belt.
16) Remove the crankshaft sprocket.
'7) Remove the left timing belt.
13
(1) Remove idler pulley.
(2) Remove plug rubber and then remove plug screw
from belt tension adjuster lower side.
Fig. 26
(3) I nsert a flat-blade screwdriver into hole on bottom of
belt tension adjuster. Turn screw clockwise to compress
rubber boot. Install BELT ADJUSTER STOPPER
(13082AAOOO), then remove belt tension adjuster.