Subaru XT 1988 Service Manual page 154

2-2 ON-CAR SERVICES
Fig. 27
(4) Remove the left timing belt.
18) Remove the oil pump ASSY.
RE INSTALLATION
1) Install the oil pump ASSY.
Replace the gasket with a new one.
2)
Install the timing belt. (Refer to Chapter
"2-3.")
Timing belts should be replaced when engine is cold.
3) Install the belt cover on the cylinder block.
4) Install the crank pulley.
Lock the crank pulley using the STOPPER [49827700 (MT)I
498497000 (AT)].
Tightening
torque:
89 - 107 N'm (9.1 - 10.9 kg-m, 66 - 79 ft·lb)
Apply a coat of engine oil to the crank pulley bolts before
installation.
5) Install the water pump pulley.
Water Pump Assembly
I
1800
cc
model
I
REMOVAL
1) Open the front hood.
2) Disconnect the ground cable from the battery.
3} Drain the coolant completely.
4)
Remove the alternator and V -belt.
5}
Disconnect the radiator outlet hose.
Fig. 28
6)
Disconnect the water by-pass hose from the pipe.
6) Install the alternator bracket, tension pulley and alterna-
L2-10B1
tor. Fig.
29
7) Install V-belt, then adjust belt tension. (Refer to Chapter
"2-3. ")
8) Install the condenser and radiator fan shroud and connect
the fan motor connectors.
9) Install the pulser ASSY (A/C)'
10) Connect the ground cable to the battery.
11) Add engine oil to the oil pan.
12) Start the engine.
13) Close the front hood and release the lift arm.
7) Unfasten clips which secure the oil pressure switch har-
ness.
8) Remove the oil level gauge guide.
9) Remove the water pump pulley.
10) Using the stopper, remove the crank pulley.
14
•