Subaru XT 1988 Service Manual page 152

2-2
ON-CAR SERVICES
17) Remove the belt idler.
L2-828
Fig, 20
18) Using the CAMSHAFT SPROCKET WRENCH
(499207000), remove the left camshaft sprocket.
19) Remove the belt cover No.2 (LH) and the rear belt cover.
20) Remove the oil pump ASSY.
REINSTALLATION
1) Install the oil pump ASSY.
Replace the gasket with a new one.
2) Install the belt cover (RR) and the belt cover No.2 (LH).
3) Install the camshaft sprocket on the right and left cam·
shafts. Lock the camshaft using the CAMSHAFT SPROCKET
WRENCH (499207000).
4) Install the timing belt. (Refer to Chapter "2·3.")
Timing belts should be replaced when engine is cold.
7.) Install the left and right belt covers.
8) Install the oil level gauge guide.
9) Install the water pump pulley.
10) Install the alternator and V-belt, then adjust belt tension.
11) Install the radiator fan shroud and connect the connector.
12) Fasten the canister hose, etc. to the clamps.
13) Install the timing hole plug.
14) Lower the vehicle.
15) Connect the grou nd cable to the battery.
16) Start the engine.
17) Add engine oil to the oil pan.
18) Close the front hood and release the I ift arm.
2700
cc
model
REMOVAL
1) Open the front hood.
2) Disconnect the ground cable from the battery.
3) Position the lift arm and raise the vehicle with a jack.
4) Remove the bolts from the lower side of the radiator and
condenser fan shroud.
L2·1407
Fig. 21
5)
Lower the vehicle.
5)
Install the belt cover (FR) on the cylinder block. 6) Disconnect the radiator and condenser fan motor connec-
Install the belt cover seals (F Rand R R) and the belt cover tor.
plug on the belt cover (FR) in advance. 7) Remove the bolts from the upper side of the shroud.
Before installing the belt cover (F R), check that there are no
bolts, washers, etc. left in the cover.
6) Install the crank pulley.
Lock the crank pulley using the STOPPER [49827700 (MT)/
498497000 (AT)
1 •
Tightening torque:
93 - 103 N·m (9.5 - 10.5 kg-m, 69 - 76 ft·lb)
Apply a coat of engine oil to the crank pulley bolts before
installation.
Sub fan shroud
Main fan sh roud
L2·1408
Fig.
22
12