A-D CONVERTER
8.7 Repeat mode
8.7 Repeat mode
In the repeat mode, the operation for the input voltage from the one selected analog input pin is performed
repeatedly.
In this mode, no A-D conversion interrupt request occurs. Additionally, the A-D conversion start bit (bit 6 at
address 1E
) remains set to "1" until it is cleared to "0" by software, and the operation is performed
16
repeatedly while the A-D conversion start bit is "1."
8.7.1 Settings for repeat mode
Figure 8.7.1 shows an initial setting example of repeat mode.
8–20
7751 Group User's Manual