Table of Contents
Advertisement
8.9 Repeat sweep mode 0
In the repeat sweep mode 0, the operation for the input voltage from the multiple selected analog input pins
is performed repeatedly. The A-D converter is operated in ascending sequence from the AN
In this mode, no A-D conversion interrupt request occurs. Additionally, the A-D conversion start bit (bit 6 at
address 1E
) remains set to "1" until it is cleared to "0" by software, and the operation is performed
16
repeatedly while the A-D conversion start bit is "1."
8.9.1 Settings for repeat sweep mode 0
Figure 8.9.1 shows an initial setting example of repeat sweep mode 0.
7751 Group User's Manual
A-D CONVERTER
8.9 Repeat sweep mode 0
pin.
0
8–27
Advertisement
Table of Contents
