Connecting To Peripheral I/F - Mitsubishi Electric GT16 User Manual

22.2.5 Connecting to PERIPHERAL I/F

Q172DCPU-S1
Q173DCPU-S1
PLC CPU
Q172DSCPU
Q173DSCPU
Q170MCPU
Q170MSCPU
Q170MSCPU-S1
MR-MQ100
*2
PLC
Communication
Model name
type
Motion
controller CPU
(Q Series)
Q172DCPU-S1
Q173DCPU-S1
Q172DSCPU Ethernet
Q173DSCPU
Q170MCPU
Q170MSCPU
Q170MSCPU-S1
MR-MQ100
*1 The destination connected with the twisted pair cable varies with the configuration of the applicable Ethernet network system.
Connect to the Ethernet module, hub, transceiver or other system equipment corresponding to the applicable Ethernet network system.
Use cables, connectors, and hubs that meet the IEEE802.3 10BASE-T/100BASE-TX standard.
The use of shielded twisted pair cable (STP) is recommended in environments in which the performance against noise is required.
A cross cable is available for connecting the GOT to the Ethernet module.
*2 When using the peripheral I/F of Q170MCPU, Q17nDCPU-S1 or MR-MQ100, set as shown below.
• Use the GT Designer3 Version1.12N or later.
• Use [Ethernet(MELSEC), Q17nNC, CRnD-700(Gateway)] for the communication driver.
• Select [QnUDE(H)] for [Controller Type] in [Ethernet] of GT Designer3.
For [Ethernet] of GT Designer3, refer to the following.
Connection cable
Connection cable
conversion box
*1
• 10BASE-T
GT16H-CNB-42S
Shielded twisted pair cable
(STP) or unshielded twisted
pair cable (UTP) : Category 3,
4, and 5
• 100BASE-TX
Shielded twisted pair cable
GT16H-CNB-37S
(STP) : Category 5 and 5e
22.3.3 Ethernet setting
Connector
conversion
box
External cable
Connector
External cable
GT16H-C30-42P(3m)
GT16H-C60-42P(6m)
GT16H-C100-42P(10m)
GT16H-C30-37PE(3m)
GT16H-C60-37PE(6m)
GT16H-C100-37PE(10m)
22. ETHERNET CONNECTION
22.2 System Configuration
Communication driver
Ethernet(MELSEC),Q17nNC,CRnD-700
GOT
Number of
GOT Total
connectable
Model distance
equipment
16 GOTs for
30m
1 network
22 - 13
20
21
22
23
24
25
26
27