Device Range That Can Be Set; Precautions; Direct Connection To Cpu; Ethernet Connection - Mitsubishi Electric GT16 User Manual

27.6 Device Range that Can Be Set

For details on the device range of controllers that can be
used on GT16 Handy, refer to the following manuals.
GT Designer3 Version1 Screen Design Manual
(Fundamentals)
GOT1000Series Connection Manual
(Mitsubishi Products) for GT Works3

27.7 Precautions

27.7.1 Direct Connection To CPU


Version of CNC
For MELDAS C6/C64, use NC system software version
D0 or later.

27.7.2 Ethernet connection


Via network system
GOT with Ethernet communication cannot access the
CNCs in another network via the CNC (network
module, Ethernet module, etc.).

When connecting to multiple GOTs
When connecting two or more GOTs in the Ethernet
network, set each [PLC No.] to the GOT.
27.4.1 Setting communication interface
(Communication settings)

When connecting to the multiple network
equipment (including GOT) in a segment
By increasing the network load, the transmission speed
between the GOT and CNC may be reduced.
The following actions may improve the communication
performance.
• Using a switching hub
• More high speed by 100BASE-TX (100Mbps)
• Reduction of the monitoring points on GOT Ethernet
cable connection
27 - 8
27. CNC CONNECTION
27.6 Device Range that Can Be Set

Ethernet cable connection
Ethernet cable is so susceptible to noise that you
should wire power cables and electric supply cables
separately. And you need to attach a ferrite core
(attachment) on the control unit side.
For details of the Ethernet cable connection, refer to the
following
MELDAS C6/C64/C64T NETWORK MANUAL
BNP-B2373 IX Connection Function with GOT
LED1
1 turn
Ferrite
core
Ferrite
Ethernet
core
FG cable for Ethernet

Version of CNC
For MELDAS C6/C64, use NC system software version
D0 or later.
GOT