Connecting To Se3000; Connecting To Ju - Mitsubishi Electric GT16 User Manual

40.5.8 Connecting to SE3000


Key Lock setting
To write the Digital and the Analog parameters, set the
Key Lock setting.

Communication settings
Make the communication settings using the
engineering software package(PASS)
Item
Protocol MODBUS RTU
*1*3
1 to 31
Station No.
*2*3
9600bps, 19200bps
Transmission speed
Data length 8bit (fixed)
*2
Even, Odd, Non
Parity bit
*2
1bit, 2bit
Stop bit
Transmission code Binary (fixed)
Error check CRC-16 (fixed)
*1 Avoid duplication of the station No. with any of the other units.
*2 Adjust the settings with GOT settings.
*3 Instrument No. and Transmission speed can also be set by
switch SW1.

Setting by Switch(SW1)
Station No. and Transmission speed can be set.
(1)
Station No.
SW1-1 SW1-2 SW1-3 SW1-4
OFF OFF OFF
ON OFF OFF
OFF ON OFF
ON ON OFF
ON OFF ON
OFF ON ON
ON ON ON
(2) Transmission speed
SW1-6 SW1-7 Communication port
OFF OFF Upper communication
OFF ON Upper communication
ON OFF ENG
ON ON
40 - 14
40. CONNECTION TO CHINO CONTROLLER
40.5 Controller Side Setting
Set value
SW1
SW1-5 Station No.
OFF OFF 1
OFF OFF 1
OFF OFF 2
OFF OFF 3
:
ON ON 29
ON ON 30
ON ON 31
Transmission speed
9600bps
19200bps
-
User setting inhibited

Setting by Switch(SW2)
DIN rail side
Upside
Terminal side
SW2
Front side (Terminal side)
RS232C

40.5.9 Connecting to JU


Key Lock setting
To write the Digital and the Analog parameters, set the
Key Lock setting.

Communication settings
Set the communication settings with controller key
operation.
Item
Protocol
*1
Station No.
*2
Transmission speed
*2
Character
(Bit length, Parity bit, Stop bit)
*1 Avoid duplication of the station No. with any of the other units.
*2 Adjust the settings with GOT settings.
422A
/485
232C
Back side(DIN rail side)
RS422A/485
Set value
rtU
1 to 99
9600bps, 19200bps
[8N1]: 8bit, None, 1bit
[8N2]: 8bit, None, 2bit
[8E1]: 8bit, Even, 1bit
[8E2]: 8bit, Even, 2bit
[8O1]: 8bit, Odd, 1bit
[8O2]: 8bit, Odd, 2bit