Mitsubishi Electric GT16 User Manual page 547

(2) Exchange condition setting switch
Exchange
Setting
condition Description
Switch
setting switch
Selection of
line processing
SW1
at TCP timeout
error
Data code
SW2
*2
setting
Self start mode
SW3
*2
setting
SW4
(Must not to be
SW5
used)
SW6
CPU exchange
SW7
timing setting
SW8 Initial timing:
: Necessary
*1 Because port No. 5001 is fixed, these items operate at the
following setting without relations to the setting given here.
• Data code setting : "Binary code"
• Write during RUN : "Enable Write at RUN time" (Writing
*2 When SW3 is ON, the initial processing is executed
regardless of the initial request signal (Y19).
In addition, communication is applicable while stopping the
PLC CPU.
For the initial processing by using the initial request signal
(Y19), refer to the following manual.
For QnA Ethernet Interface Module User's Manual
POINT POINT POINT
When the switch setting has been changed
Turn the PLC CPU OFF then ON again, or reset the
PLC CPU.
Set Setting necessity
value at GOT connection
OFF
OFF
(fixed)
ON
OFF
(fixed)
OFF
*1
(fixed)
OFF
: As necessary : Not necessary
Data is applicable while running the
PLC CPU.)

[Network parameter] of GX Developer
(1) Network parameter
Item
Network type Ethernet (fixed)
Start I/O No.
*1
Network No.
Group No.
*2
Station No.
IP address 192.168.0.19
Station No.<->IP information
FTP Parameters (Use default value)
Router relay parameter
Routing parameters Refer to (2)
: Necessary
*1 Set the same network No. as that of the GOT.
*2 Do not set the same station No. as that of the GOT.
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU,
operate the PLC CPU either turning OFF and then ON
or resetting.
22. ETHERNET CONNECTION
22.4 PLC Side Setting
Setting necessity at
Set value
GOT connection
0000
H
1
0 (fixed)
2
: As necessary : Not necessary
22 - 37
20
21
22
23
24
25
26
27