Mitsubishi Electric GT16 User Manual page 406

Error
Error message
code
Warning! Backlight needs
502
replacement soon.
Warning! Display section needs
503
replacement soon.
Warning! Touch panel needs
504
replacement soon.
Warning! Built-in Flash ROM
505
needs replacement soon.
Warning! Backlight needs
506
replacement.
Warning! Display section needs
507
replacement.
Warning! Touch panel needs
508
replacement.
Warning! Built-in Flash ROM
509 needs replacement. Change the
GOT.
510 Clock data input out of range
19 - 18
19. TROUBLESHOOTING
19.2 Error Message and System Alarm
The dedicated GS is notifying that the backlight power on addition time
has reached 80% or more of the set time.
The GOT can be restored by executing the addition times reset function
after replacing the backlight. The GOT can also be restored by turning
off the notification signal manually. In such a case, turn it OFF after
setting a value greater than the addition time.
The dedicated GS is notifying that the display section power on addition
time has reached 80% or more of the set time.
The GOT can be restored by executing the addition times reset function
after replacing the display section. The GOT can also be restored by
turning off the notification signal manually. In such a case, turn it OFF
after setting a value greater than the addition time.
The dedicated GS is notifying that the touching count of the touch key
has reached 80% or more of the set count number.
The GOT can be restored by executing the addition times reset function
after replacing the touch key. The GOT can also be restored by turning
off the notification signal manually. In such a case, turn it OFF after
setting a value greater than the addition times.
The dedicated GS is notifying that the built-in flash memory writing
times have reached 80% or more of the set times.
The GOT must be replaced. In that case, Data backup and re-setting
are needed. The GOT can also be restored by turning off the
notification signal manually. In such a case, turn it OFF after setting a
value greater than the addition times.
The dedicated GS is notifying that the backlight power on addition time
has reached the set time or more.
The GOT can be restored by executing the addition times reset function
after replacing the backlight. The GOT can also be restored by turning
off the notification signal manually. In such a case, turn it OFF after
setting a value greater than the addition time.
The dedicated GS is notifying that the display section power on addition
time has reached the set time or more.
The GOT can be restored by executing the addition times reset function
after replacing the display section. The GOT can also be restored by
turning off the notification signal manually. In such a case, turn it OFF
after setting a value greater than the addition time.
The dedicated GS is notifying that the touching count of the touch key
has reached the set count number or more.
The GOT can be restored by executing the addition times reset function
after replacing the touch key. The GOT can also be restored by turning
off the notification signal manually. In such a case, turn it OFF after
setting a value greater than the addition times.
The dedicated GS is notifying that the built-in flash memory writing
times have reached the set times or more.
The GOT must be replaced. In that case, Data backup and re-setting
are needed. The GOT can also be restored by turning off the
notification signal manually. In such a case, turn it OFF after setting a
value greater than the addition times.
The value that is input as clock data is out of the input enabled range.
In this case, the input value is not accepted.
Confirm the input range of the value to be input as clock data, and input
the proper value again.
Action
Channel No.
storage