Mitsubishi Electric GT16 User Manual page 790


Ethernet setting
Item Description
The host is displayed. (The host is
Host
indicated with an asterisk (*).))
Set the network No. of the
N/W No. connected Ethernet module.
(Default: blank)
Set the station No. of the
*1
connected Ethernet module.
PLC No.
(Default: blank)
Type OMRON (fixed)
Set the IP address of the
IP address connected Ethernet module.
(Default: blank)
Set the port No. of the connected
Port No. Ethernet module.
(Default: 9600)
Communication Select a communication protocol.
format (Default: UDP)
*1 Each of [GOT PLC No.] set in the communication detail
setting and [PLC No.] set in the Ethernet setting must be set
to different station numbers.
33.3.2  Communication detail settings
POINT POINT POINT
(1) Communication interface setting by the Utility
The communication interface setting can be
changed on the Utility's [Communication setting]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following.
12. COMMUNICATION INTERFACE SETTING
(COMMUNICATION SETTING)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
33 - 24
33. CONNECTION TO OMRON PLC
33.3 Ethernet Connection
Set value
―
1 to 127
1 to 254
OMRON (fixed)
PLC side IP
address
256 to 65534
UDP, TCP