Mitsubishi Electric GT16 User Manual page 84

(2) Mounting on the panel face
(When installing the Connector Conversion Box on the panel surface)
(a) Direct mounting on the panel face
Drill a mounting slot of the following size on the panel face.
(b) Mounting on the panel face
Install the Connector Conversion Box on the panel face (mounting surface).
Tighten the mounting screw with the specified torque. Tightening screws too much may cause damage.
Tightening torque
(3) Installation on the DIN rail.
Install the Connector Conversion Box on the DIN rail with using
its DIN rail hook.
Applicable DIN rail
The clearance between screws for installing the DIN rail should
be 150 mm or less.
1) Pull out the hook for
DIN rail.
6 - 12
6. OPTION
6.7 Connector Conversion Box
0.69 to 0.88 N•m
DIN46277 (width: 35mm)
2) Adapt the upper side of the DIN rail
installation slot to the DIN rail.
ON
OFF
M4 screw and nut
× 4 sets 4- 4.5 (0.18 " )
(prepared by user)
3) Lock the hook for DIN rail while forcing
the product on the DIN rail.
When installing the DIN rail, please fix
the cables. Otherwise, the hook for DIN
rail and other parts may be damaged by
the cable load.
43 (1.7 " ) 6 (0.24 " )
ON
OFF
Unit: mm (inch)
DIN rail depth
more than 10mm (0.4 "inch )
ON
OFF