Mitsubishi Electric GT16 User Manual page 846

37.6 Device Range that Can Be Set
For details on the device range of controllers that can be
used on GT16 Handy, refer to the following manuals.
GT Designer3 Version1 Screen Design Manual
(Fundamentals)
GOT1000Series Connection Manual
(Non-Mitsubishi Products 1) for GT Works3
37.7 Precautions

Station No. settings of the PLC side
In the system configuration, the PLC with the station
number set with the host address must be included.For
details of host address setting, refer to the following.
37.4.1 Setting communication interface
(Communication settings)

GOT clock control
The GOT clock function is available only for the PLC
with the station number set with the host address.
For details of host address setting, refer to the
following.
37.4.1 Setting communication interface
(Communication settings)

System configuration
If the system is configured by mixing the PC3J
extended function compliant PLC with the PC3J
extended function incompliant PLC, normal
communication may not be performed.Unify the PLCs
into PC3J extended function compliant or PC3J
extended function incompliant to configure the system.

System alarm
The system alarm can be displayed only for the PLC
set with a host address.When connected to the PC3J
extended function compliant PLC, only the system
alarm of program No. 1 can be displayed.

Version of PC3J
For PC3J, use version 2.1 or later.
37 - 12
37. CONNECTION TO JTEKT PLC
37.6 Device Range that Can Be Set