Mitsubishi Electric GT16 User Manual page 541

(2) Operation setting
Item
*1
(Use default value)
Communication data code
IP address 192.168.0.19
*1
Initial timing
Send frame setting
(Use default value)
*1
Enable Write at RUN time
TCP Existence confirmation
setting
: Necessary
*1 Because port No. 5001 is fixed, these items operate at the
following setting without relations to the setting given here.
• Communication
data code
• Initial timing
• Write during RUN : "Enable Write at RUN time" (Writing
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU,
operate the PLC CPU either turning OFF and then ON
or resetting.
Setting necessity at
Set value
GOT connection
: As necessary : Not necessary
: "Binary code"
: "Always wait for OPEN"
(Communication is applicable while
stopping the PLC CPU.)
Data is applicable while running the
PLC CPU.)
(3) Routing parameter setting
Up to 64 [Transfer Network No.]s can be set.
However, the same transfer network number cannot be
set twice or more (multiple times).
Therefore, the one that can access to other station from
the request source host GOT is 64 kinds of [Transfer
Network No.]s.
Item
Target network No.
Relay network No.
Relay station No.
POINT POINT POINT
Routing parameter setting of request source
Routing parameter setting is also necessary for the
request source GOT.
For the setting, refer to the following.
22.3.4 Routing parameter setting
(4) Communication confirmation
The INIT. LED on the Ethernet module turns on when
the module is ready to communicate.
For confirming the communication state, refer to the
following.
■Confirming the communication state of
Ethernet module
*1 The LEDs layout of QJ71E71-100.
22. ETHERNET CONNECTION
22.4 PLC Side Setting
Range
1 to 239
1 to 239
1 to 64
*1
22 - 31
20
21
22
23
24
25
26
27