Mitsubishi Electric GT16 User Manual page 91

HINT HINT HINT
Example of the station No. switching setting procedure using the ID recognition function of the connector
conversion box.
The following shows an example of the station No. switching setting procedure using the ID recognition function of
the connector conversion box. Here, an example to set the station No. switching device value using the status
observation function is explained.
1.
Set the ID number of the connector conversion box.
The ID number of the connector conversion box will be the PC No. of the PLC to be monitored.
■Setting the ID number
2.
Switch the serial communication interface of the handy GOT.
For the communication using RS-232, open the environmental protection back cover on the main unit back side and
connect the RS-422/485
Selection of RS-232 connection and RS-422/485 connection
3.
Install the communication driver to the handy GOT.
Install the Ethernet communication driver to be used in the communication with the controllers and the MODBUS/
RTU communication driver to be used in the communication with the connector conversion box to the handy GOT.
■GOT side settings
4.
Make the controller settings of the project data to be transferred to the handy GOT.
• Controller setting
Make the settings to connect the GOT to Ethernet.
RS-232 selection connector to the RS-232 side.
6. OPTION
6.7 Connector Conversion Box
1
2
3
4
5
6
7
8
6 - 19