Parameter Setting (When Connecting To C Controller Module (Q Series)) - Mitsubishi Electric GT16 User Manual

(2) Station information setting
*1
Item
Intelligent device
*2
Station type
Number of stations
Exclusive station 1 (fixed)
occupied
Reserve/invalid station
select
Intelligent buffer select
(Use default value)
(word)
: Necessary
*1 When the [Mode] of the CC-Link module is set at [Remote
net - (Ver. 2 mode)], [Remote station points] is available to
set.
[Remote station points] is a setting for the remote I/O station.
The default value (32 points) must be used on the GOT.
*2 When the [Mode] of the CC-Link module is set at [Remote
net - (Ver. 2 mode)] or [Remote net - Additional mode], set to
[Ver. 1 Intelligent device station].
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU,
operate the PLC CPU either turning OFF and then ON
or resetting.
(3) Completion confirmation
After initial communications of CC-Link are completed,
the L RUN LED of AJ65BT-G4-S3 turns on.
The GOT starts to monitor after the L-RUN LED of
AJ65BT-G4-S3 turns on.
It does not monitor while the L RUN LED turns off.
23 - 12
23. CC-Link CONNECTION (Via G4)
23.5 PLC Side Setting
Setting necessity at
Set value
GOT connection
station (fixed)
No setting
: As necessary : Not necessary
23.5.5 Parameter setting (when
connecting to C controller
module (Q Series))
Use SW3PVC-CCPU-E Ver.3.05F or later for the C
Controller module (Q Series) setting utility.
(1) Target module
Item
*1
Target module
Write authority Mark the checkbox
*2
User name
*2
Password
Detailed settings
: Necessary
*1 If the IP address of the C controller module (Q Series) has
been changed, input the changed IP address or host name.
*2 If the account of the C controller module (Q Series) has been
changed, input the changed user name and password.
Setting necessity at
Set value
GOT connection
192.168.3.3
target
password
-
: As necessary : Not necessary