Mitsubishi Electric GT16 User Manual page 71

Got1000 series

Hide thumbs Also See for GT16:

Table of Contents

Configure the system to meet the EMC Directive specifications for the connected device when connecting the GOT

to a controller.

The following gives the instructions to ensure the machinery comply with the EMC Directive. However, the

manufacturer of the machinery must finally determine how to make it comply with the EMC Directives: if it is

actually compliant with the EMC Directives.

(a) For RS-422 / 485 cable

• Each signal wire (excluding SG and FG) should be made into a two power wires and connected, then

• Make the SG wire more than two wires and connect.

(b) For RS-232 cable

• Use a twisted pair style for each signal wire (except SG, FG) with SG.

• Attach the ferrite core to the cable in the position as illustrated below.

Ferrite Core

(ZCAT3035-1330)

5. UL, cUL STANDARDS AND EMC DIRECTIVE

Unit : mm (inch)

5.2 EMC Directive

Chapters

Table of Contents