Back Panel - Mitsubishi Electric GT16 User Manual

4.2 Back Panel

4.2.1 Name and specifications
Environmental protection back cover closed
(7)
No. Name
(1) External interface connector
Environmental protection back
(2)
cover
Environmental protection back
(3)
cover screw
(4) Hook for hanging on walls
(5) Hand strap
(6) Grip angle changing screw
(7) Grip switch
(8) Battery
Connector for battery
(9)
connection
(10) RS-232 connector
(11) RS-422/485 connector
Cable connector for PLC
(12)
communication
Terminating resistor setting
(13)
switch
4 - 2
4. PARTS NAME
4.2 Back Panel
(4)
(1)
(3)
For external cable connection (for PLC, switch and power supply external wiring) (connector: square 42 pins,
male)
Opened and closed when the PLC communication type is changed (RS-422/485
shipping: RS-422/485), or the battery is replaced.
For opening and closing the environmental protection back cover (drop prevention screw)
Hook when the Handy GOT is used hanging on walls.
Used to hold the Handy GOT in hand by putting a hand under the strap. Length adjustable.
Used when changing the angle of the grip. (5, M4 screw)
The angle of the grip can be set either to the standard angle (as before shipping) or 15 degrees to the right.
Switch for external direct wiring (independent contact)
For storing clock data, maintenance timing notification and system log data
For battery connection
Connector for PLC communication using RS-232
Connector for PLC communication using RS-422/485
Interface cable connector for PLC communication
Connector for either (10) or (11) and for selection of the PLC communication type.
(Connected to RS-422/485 before shipping.)
For switching the RS-422/485 communication interface terminating resistor
(Set to "Disable" before shipping)
Environmental protection back cover opened
(5)
(6)
Terminating resistor setting switch enlarged view
Terminating
resistor
Enable
Disable
(2)
Set to "Disable" before shipping
Specifications
ON side
ON
Switch No.
1 2
ON ON
1 2
OFF OFF
OFF side
RS-232, before
(10)
(11)(12)
(13)
(9)
(8)