Mitsubishi Electric GT16 User Manual page 557

22.4.12 Connecting to Built-in Ethernet
port FXCPU (FX
This section describes the settings of the GOT and
Ethernet module (FX Series) in the following case of the
system configuration.
POINT POINT POINT
FX
3GE
For details of the FX , refer to the following manual.
3GE
FX SERIES PROGRAMMABLE
3GE
CONTROLLERS HARDWARE MANUAL

System configuration
■
[Controller Setting] and [Ethernet] of GT
Designer3
<Ethernet module> (The settings other than the
following are set to the default)
Network No.
PC No.
IP address
Port No.
Communication
format
■ Ethernet parameter setting of FX3GE
*1 These setting items do not exist at the PLC side. However,
the virtual values must be set on the GOT side.
■ [Controller Setting] and [Ethernet] of GT
Designer3
)
3GE
<GOT>
(The settings other than the
following are set to the default)
PLC No. : 1
IP address : 192.168.0.18
Port No. : 5019
Communication : TCP (fixed)
format
*1
: 1 (virtual)
*1
: 2 (virtual)
: 192.168.0.19
: 5556 (fixed)
: TCP (fixed)

Ethernet parameter setting of FX
(1) Ethernet setting
Set the Ethernet parameter at [FX Parameter] on GX
Works2.
To set FX , GX Works2 Ver.1.91V or later is required.
3GE
For details on the setting of FX
manual.
FX SERIES PROGRAMMABLE
3GE
CONTROLLERS HARDWARE MANUAL
Item Setting
Channel CH1
IP Address
192.168.1.250
Open Settings Refer to (2)
Communication Data
Code
Disable direct
connection to
(Use default value.)
MELSOFT
Do not respond to
search for CPU on
network
: Necessary
*1 The default value of IP address is 192.168.1.250. Set the IP
address corresponding to the system configuration.
POINT POINT POINT
When changing Ethernet parameter
After writing Ethernet parameters to the PLC CPU, turn
the PLC CPU OFF then back ON again.
22. ETHERNET CONNECTION
22.4 PLC Side Setting
3GE
, refer to the following
3GE
Setting
(with GOT connected)
*1
: As necessary : Not necessary
22 - 47
20
21
22
23
24
25
26
27