Mitsubishi Electric GT16 User Manual page 83


Installation (GT16H-CNB-42S)
The Connector Conversion Box can be installed on the panel face directly or on the DIN rail.
(1) Mounting on the panel face
(When setting the connector for Handy GOT connection and the power supply switch on the panel surface)
(a) Direct mounting on the panel face
Drill a mounting slot of the
following size on the panel
face.
(b) Installation of the packing
Install the accessory packing to the packing attachment
chase of the Connector Conversion Box.
Be sure to install the packing.
(c) Mounting on the panel face
Fit the Connector Conversion Box from the back side of the panel face, and fix it with four M4 screws
(prepared by user).
In the Connector Conversion Box, thread of M4, 6 mm in depth is cut in each mounting hole.
Prepare four M4 mounting screws separately while considering the thickness of the panel face.
Tighten the mounting screw with the specified torque. Tightening screws too much may cause damage.
Tightening torque
Make sure that interfering objects are not located within 65 mm from the rear face so that the connector of
a PLC cable is not hindered.
To wire the terminal block, keep a space of 25 mm or more on both sides of the Connector Conversion Box.
4-R3 max (Panel opening)
0.69 to 0.88 N•m
Drill 4- 5±0.5 (0.2 " ±0.02 " )
77±0.5 (3.04 " ±0.02 " )
61+1,-0 (2.41 " ±0.04 ",-0 )
(Panel opening)
Packing attachment chase
ES1A ES1B ES2A ES2B ES3A ES3B
ES1A ES1B ES2A ES2B ES3A ES3B
ON
OFF
RS-232
RS-422
10BASE-T
SW-COM SW2 SW4 SW6
100BASE-TX
SW1 SW3 SW5
65 (2.56 " )
6. OPTION
6.7 Connector Conversion Box
Panel cut area
Unit: mm (inch)
Elevation view
25 (0.99 " )
FG
-INPUT 24VDC+
ID No.
U L
KSW1 DSW1 DSW2
KSW-COM KSW2 DSW1 DSW2
25 (0.99 " )
Unit: mm (inch)
6 - 11
1
2
3
4
5
6
7
8