Connecting To Interface Converter (Ks-485); Connecting To Interface Converter (K3Sc-10) - Mitsubishi Electric GT16 User Manual

48.5.6 Connecting to interface
converter (KS-485)

Communication settings
Make the communication settings using setting
switches.
Item
Transmission speed
*1
Terminating resistor selection
*1 Set as necessary.

Settings by switch
RS-485
RS-232C
Front
(1) Settings of transmission speed and terminating
resistor selection
Setting item Set value
1 2
Transmission
9600bps ON OFF ON
speed
Terminating Enable
resistor
Disable
*1
selection
*1 Set as necessary.
*2 Disabled.
Set value
9600bps
ON/OFF
Communication
setting switch
Rear
Switch No.
*2 *2
3 5 7 8
4 6
- ON -
ON ON
OFF OFF
48. CONNECTION TO FUJI TEMPERATURE CONTROLLER
48.5.7 Connecting to interface
converter (K3SC-10)

Communication settings
Make the communication settings by operating the DIP
switch of the temperature controller.
Item
*1
9600bps, 19200bps, 38400bps
Transmission speed
Data bit 8bits
*1
Odd, even, none
Parity bit
Stop bit 1bit
Communication Type RS-232C
Echo back Without
*1 Make the same setting as that of GOT side.

Settings by DIP switch
Front of K3SC-10 body Inside of K3SC-10 body
(When removing the front cover)
(1) Transmission speed settings
Switch No.
Transmission speed
(bps)
1 2
9600 OFF OFF
19200 ON OFF
38400 OFF ON
48.5 Temperature Controller Side Setting
Set value
RS-485
Terminal block
for RS-422/485
communication
DIP switch
Terminal block
for RS-232
communication
3
OFF
Set these
switches.
ON
ON
SW
ON
48 - 9
44
45
46
47
48
49
50
51