Table of Contents
Advertisement
*1
The destination connected with the twisted pair cable varies with the configuration of the applicable Ethernet network system.
Connect to the Ethernet module, hub, transceiver or other system equipment corresponding to the applicable Ethernet network
system.
Use cables, connectors, and hubs that meet the IEEE802.3 10BASE-T/100BASE-TX standard.
A cross cable is available for connecting the GOT to the Ethernet module.
The use of shielded twisted pair cable (STP) is recommended in environments in which the performance against noise is
required.
*2
A length between a hub and a node.
The maximum distance differs depending on the Ethernet device to be used.
The following shows the number of the connectable nodes when a repeater hub is used.
• 10BASE-T: Max. 4 nodes for a cascade connection (500m)
• 100BASE-TX: Max. 2 nodes for a cascade connection (205m)
When switching hubs are used, the cascade connection between the switching hubs has no logical limit for the number of
cascades.
For the limit, contact the switching hub manufacturer.
*3
For the system configuration of the Ethernet module, refer to the following manuals.
*4
Select one of the following [Controller Type] in [Ethernet] of GT Designer3.
• Ethernet module (FX Series): FX
For [Ethernet] of GT Designer3, refer to the following.
*5
When using an Ethernet module with the FX
*6
When using an Ethernet module with the FX
*7
FX
communication adapter CH (Max. 1 CH) of the FX
22 - 8
22. ETHERNET CONNECTION
22.2 System Configuration
For FX Ethernet Interface Module User's Manual
22.3.3 Ethernet setting
-ENET-ADP occupies one extension communication adapter CH (Max. 2 CHs) of the FX
3U
series, FX
-1PS-5V or FX
3UC
3UC
2NC
series, FX
-CNV-BD, FX3U-422-BD, or FX
3U
3U
. One CPU allows the connection of only one FX
3S
-CNV-IF is required.
-232-BD is required.
3U
or FX
and one extension
3U(C)
3G(C)
-ENET-ADP.
3U
Advertisement
Chapters
Table of Contents
