Communication Setting Contents - Mitsubishi Electric GT16 User Manual

Got1000 series
Hide thumbs Also See for GT16:
Table of Contents

Advertisement

12.1.3 Communication setting contents

This section describes setting items and display contents for Communication Setting.
(3)
(1) Channel-Driver assign
Channel No. can be assigned to the communication driver installed in the GOT.
(a) Not writing [Communication Settings] in GT Designer3
Without writing [Communication Settings] in GT Designer3, communication with a controller is available
after assigning the channel No. with this function.
(b) When changing the assignment of the communication driver to the channel in the Utility
Without using GT Designer3, the assignment of communication drivers to channels can be changed.
(When change a communication driver, the alternative communication driver has to be installed in GOT in
advance.)
(2) Standard interface display BOX
Display the communication interface included as standard in GT16 Handy.
There are the following 4 types.
For GT16 Handy, extend I/F-1 and I/F-2 are not available.
RS-232.................. For communicating with controller
RS-422/485........... For communicating with controller
USB....................... For communicating with PC (GT Designer3)
Ethernet................. For communicating with PC (GT Designer3), controller
12 - 2
12. COMMUNICATION INTERFACE SETTING (COMMUNICATION SETTING)
12.1 Communication Setting
(2)
12.1.4 ■Channel-Driver assign operation
(5)
(1)
(4)
(2)
(3)
(4)
Ethernet interface
RS-232 interface
RS-422/485 interface
RS-422/485 interface and RS-232 interface
cannot be used at the same time.
Switch the RS-422/485 interface and RS-232
interface with the RS-422/485
selection connector in the environmental
protection back cover.
(2)
(4)
(2)
(4)
RS-232

Advertisement

Table of Contents
loading

Table of Contents