Mitsubishi Electric GT16 User Manual page 713


Connecting the GOT and PLC in Ethernet
connection (when connecting to QCPU (Q
mode))
1.
Click [Online] [Read from PLC] in GX Developer.
2.
Set the [PLC Series] to [QCPU(Q mode)].
3.
The [Transfer Setup] is displayed.
4.
Set the [Transfer Setup]:
PC side I/F : Serial USB (COM)
PLC side I/F : PLC module
Other station : No specification
5.
Double-click [Serial] of the PC side I/F to display [PC
side I/F Serial setting].
6.
Check the following for [PC side I/F Serial setting].
When connecting the GOT and PC with USB
Mark the [USB] checkbox.
7.
Double-click [PLC module] of the PLC side I/F to
display [PLC side I/F Detailed setting of PLC module].
8.
On the [PLC side I/F Detailed setting of PLC module],
mark the [via GOT(Ethernet) transparent mode]
checkbox and click [Set].
9.
By clicking [Set], the [GOT (Ethernet) transparent
setting] is displayed.
Here, set the built-in Ethernet port QCPU or Ethernet
module, which is firstly connected via a GOT.
10.
Set [QnUDE(H)] or [QJ71E71] for [Type name].
When connecting the CNC C70, set [QJ71E71].
When connecting the Q170MCPU, set [QnUDE(H)].
When connecting the Q173NCCPU, set [QJ71E71].
11.
Specify the number for [Network No.] and [Station
No.] same as the number assigned to the Ethernet
module.
When [QnUDE(H)] is set for [PLC type], the setting is
not required.
12.
Specify the IP address for [IP address] same as the
IP address assigned to the built-in Ethernet port
QCPU or Ethernet module.
31. FA TRANSPARENT FUNCTION
31.6 Personal Computer Side Setting
28
29
30
31
32
33
34
35
31 - 37