Display Operation Of Main Menu - Mitsubishi Electric GT16 User Manual

10.3.1 Display operation of main menu

The following four types of operation can display the main menu.
(Display the main menu after installing the basic OS from GT Designer3 to the GOT built in flash memory.)
(1) When project data is undownloaded
If the power supply of GOT turns ON, the main menu is displayed automatically after title display.
GOT power supply ON
(2) When touching menu call key
If you touch the menu call key while user-created screen is displayed, the main menu is displayed.
The menu call key is set in the position on the GOT screen upper left corner at factory shipment.
Menu call key
1-point touch on the upper-left corner
The menu call key can be set by the GOT utility or GT Designer3.
For menu call key setting, refer to the following.
11.3.5 Utility call key setting
GT Designer3 Version1 Screen Design Manual (Fundamental)
4.9 GOT Display and Operation Setting(GOT Environmental Setting: GOT Setup)
POINT POINT POINT
(1) Prohibited simultaneous 2-point presses
Do not touch 2 points or more on the GOT screen simultaneously.
Touching 2 points or more simultaneously may activate a part other than the touched point.
(2) Pressing time of the utility call key
When having set [Pressing time] of the menu call key setting screen to other than "0 (s)", keep pressing the
touch panel for the period set to [Pressing time] or more before leaving the finger from the touch panel.
For menu call key setting, refer to the following.
11.3.5 Utility call key setting
(3) When the utility call key is set to the zero point
Even when the utility call key is set to the zero point, you can display the main menu using either of the
following two operations:
• Pressing the special function switch set on the user-created screen
• Pressing the S-mode switch while the [Booting...] message which appears immediately after powering up is
displayed.
Main menu
Main menu
10. UTILITY FUNCTION
10.3 Utility Display
9
10
11
12
13
14
15
16
10 - 7