Mitsubishi Electric GT16 User Manual page 729

(2) When connecting the GOT and personal computer
in Ethernet connection
1.
Click [Transfer setup]
2.
The [Transfer Setup] is displayed.
3.
Set the [Transfer Setup]:
PC side I/F : Ethernet Board
PLC side I/F : GOT
Other station : No specification
4.
Double-click [Ethernet Board] of the PC side I/F to
display [PC side I/F Ethernet Board Setting].
5.
Set the protocol to TCP. Network No. and Station No.
are not required to be changed (default) because they
are not used.
[Online].
6.
Double-click [GOT] of the PLC side I/F to display
[PLC side I/F Detailed Setting of GOT].
7.
Set the IP address and port No. in [Ethernet detail
setting for PC and GOT connection].
Set the IP address and port No. to the same as the
Ethernet download setting.
■ Communication setting with personal
computer
8.
Check either of the followings in [Detail setting for
GOT and PLC connection].
Direct CPU connection
Mark the [via GOT(direct coupled) transparent mode]
checkbox.
9.
The screen returns to [Transfer Setup]. Click
[Connection Test] to check if GX Developer has been
connected to the Motion controller (Q mode).
31. FA TRANSPARENT FUNCTION
31.6 Personal Computer Side Setting
28
29
30
31
32
33
34
35
31 - 53