Mitsubishi Electric GT16 User Manual page 347

(b) Setup operation
Sets the project data stored in the A drive (Standard CF Card) or E drive (USB drive) to be used in the GOT.
The GOT monitors using the monitor data in the A drive.
(This item explains using the A drive.)
POINT POINT POINT
Before setup operation
When storing project data from GT Designer3 to CF card, select [A: Standard CF Card] or [E: USB drive] for
[Project Data] in [Boot Drive].
1.
Install the CF card or USB memory in GOT.
Refer to the following for inserting/removing method
of CF card or USB memory.
6.1.2 Installing and removing procedures of
the CF card
6.3.2 Installing and removing procedures of
the USB memory
2.
Touch [A: Standard CF Card] in Select drive.
3.
If touch the [Download] button, the dialog box
mentioned left is displayed.
If touch [OK] button, the setup is executed.
4.
When the setup is completed, the dialog box
mentioned left is displayed.
Touching the [OK] button restarts the GOT.
15. DATA CONTROL
15.3 OS/Project Information
9
10
11
12
13
14
15
16
15 - 99