Bar Code Reader; Bar Code Reader Types; Connecting Procedure - Mitsubishi Electric A960GOT User Manual

6 HANDLING

6.11 Bar Code Reader

6.11.1 Bar code reader types

6.11.2 Connecting procedure

6 - 31
The bar code reader is used for writing data that is read with the bar code reader into
the programmable controller CPU. For details of the functions of the bar code reader,
please refer to the [GOT-A900 Series User's Manual (GT Works Version5/GT
Designer Version5 compatible Connection System Manual).]
The following are the applicable bar code readers whose operating performance has
been checked and confirmed by Mitsubishi Electric Corporation:
• Names of manufacturer of bar code reader: Token, Opt-electronics, Keyence,
Imex, OLYMPUS-symbol, Omron and Denso
• Please note that the bar code reader cannot be used if the GOT is connected to
the MELSECNET/B or MELSECNET II.
• The power supply (5V DC) needs to be supplied from an AC-DC adapter or a
corresponding power module to the bar code reader.
• The RS-232C cable needs to be prepared by the user of this product.
For details of preparations of the cable, please refer to the [GOT-A900 Series
User's Manual (GT Works Version5/GT Designer Version5 compatible
Connection System Manual).]
1) To the RS-232C interface that is provided on the
lower part of the GOT, choose and connect one
from the following: the connector for the bar
code reader; the connector for the power supply
module; and the connector on the GOT for the
RS-232C cable. (The connecting method differs
depending on the kind of bar code reader that
will be used.)
MELSEC-GOT
6 - 31