Mitsubishi Electric GT16 User Manual page 394

(3) Wiring of GOT's FG cable and power line
Current status
Measure for the
cables installed
together
(4) Surge measures
Current status
Measure for the
equipment without
a surge suppressor
used
Entry area
Model name of the surge suppressor
19 - 6
19. TROUBLESHOOTING
19.1 GOT Restoration Sheet
GOT
FG
Power for the power equipment
GOT
FG
Power for the power equipment
PLC
Output
AC
PLC
Output
AC
The surge suppressor must be
attached close to the load
The FG cable and power line of the GOT
are installed together.
Separating the FG cable and power line of
the GOT in wiring reduces the influence of
noise.
A surge suppressor is used for the wiring of
the load such as MCCB,
electromagnetic contactor, relay,
solenoid valve, or induction motor.
C
L
R
(When a surge suppressor is used, fill out the
entry area below with the surge suppressor
model name and the name of the equipment
for which the surge suppressor is used.)
C
Attaching the surge suppressor on the
L
R
cable close to the load can reduce the
influence of surge on the GOT.
Installed
together
Not installed
together
Effective
Ineffective
Used
Not used
Effective
Ineffective
Equipment name