Mitsubishi Electric GT16 User Manual page 351

16. INSTALLATION OF COREOS,
BOOTOS AND STANDARD MONITOR
OS
For executing the GOT utility, install the BootOS and standard monitor OS on the C drive (built-in flash memory) of the
GOT, or set the OS boot drive to [A: Standard CF Card] and insert the CF card with OS files into the GOT.
(BootOS is installed in the GOT at factory shipment. It is not necessary to install BootOS when upgrading of it is
unnecessary.)
This chapter explains the installation using GOT.
GT Designer3 → CFcard/→ GOT
USB memory
GT Designer3
Set the OS boot
drive to [A: Standard
CF Card].
GOT → CF card/ → GOT
USB memory
*1 When execute installation with USB memory, standard monitor OS has to be installed in GOT in advance.
For the writing of OS in GT Designer3, refer to the following.
GT Designer3 Version1 Screen Design Manual (Fundamentals)
POINT POINT POINT
CoreOS
In 16.1 to 16.4 of this chapter, only BootOS and standard monitor OS are described.
For CoreOS, refer to the following.
16.5 CoreOS
16. INSTALLATION OF COREOS, BOOTOS AND STANDARD MONITOR OS
BootOS or
Write
standard monitor OS
OS file
installation
Install the CF
*1
CF card/USB memory card in GOT
Install the CF
Write
card in GOT
CF card
OS file
BootOS or
OS file
standard monitor OS
upload
installation
Install the CF
*1
card/USB
CF card/USB memory
memory in GOT
When GOT is remote, installed
easily using the CF card/
USB memory
The GOT can starts without an
OS installed.
Install OS from GOT to GOT
using CF card/USB memory.
16 - 1
9
10
11
12
13
14
15
16