Mitsubishi Electric GT16 User Manual page 187

(3) Channel number specification menu BOX
Set channel No. to use with standard interface.
Refer to This section (4) for driver that can be assigned to each channel.
0 : Set when the communication interface is not used.
1 to 4 : Set when connecting to a controller.
*1
: Set when connecting with PC (GT Designer3 ).
9
* : Set when using the function that uses the gateway function (when connection types except the Ethernet
connection is used for connecting to controllers), Ethernet download function.
• Fixed to 9 for the USB interface.
*1 Cannot be assigned with Ethernet I/F Assignment.
(4) Driver display BOX
The name of communication driver assigned to the channels or the driver set with the Communication Setting of
GT Designer3 is displayed.
For details of drivers to be displayed, refer to the following manual.
GT Designer3 Version1 Screen Design Manual (Fundamentals)
Display [None] in the driver display BOX in case of the followings.
• The communication driver is not installed. (
• In channel number specification menu BOX, [0] is set.
When the channel number is set to [9], the communication driver [Host (PC)] is automatically assigned.
(5) Assign Ethernet I/F
The communication settings for the Ethernet connection can be made.
Ethernet I/F Assignment can assign up to four channels per interface.
12.1.4 ■Assign Ethernet I/F operation
POINT POINT POINT
Precautions for communications between GOT and controller
(1) Installing communication driver and downloading Communication Setting
The followings below are required for the communication interface to communicate with the controller.
1) Installing communication drivers (Up to 4 communication drivers)
2) Assigning the channel number and communication driver for the communication interface
3) Downloading the contents (project data) assigned in 2).
Perform1), 2), 3) by GT Designer3.
Refer to the following for details.
17. DRAWING SOFTWARE SETTINGS (CONTROLLER SETTING AND COMMON SETTINGS)
(2) When Communication Setting has not been downloaded.
When [Communication Settings] has not been downloaded using drawing software, make the communication
settings in the drawing software or on the utility screen of the GOT.
12. COMMUNICATION INTERFACE SETTING (COMMUNICATION SETTING)
15.3.1 OS information)
12.1 Communication Setting
9
10
11
12
13
14
15
16
12 - 3